MTD FK 105 Manuel de service télécharger pdf (Page 9)

Operating Manual FK 105

___________________________________________________________________________

13. Before the sweeper can be coupled, the connection pieces for the MTD "Fast Attach

System" must be bolted on. Match the parts to the correct side according to the

illustration and attach each part using 2 bolts, 2 washers and 2 nuts.

14. Finally, the support plates, which

protect the brushes during

transport and during storage in the

carton against compressed areas, on

the ends of the brush on the right and

left must be removed.

Undo the nut of the brush axle by

approx. 3 turns using a ring spanner

SW 19 and remove the plates.

Carefully tighten the nut again

afterwards. Check the tightness after 1

hour of operation.

___________________________________________________________________________

Hex. Bolt M8x25

Thin washer

Thick washer

Lock nut M8

Sweepin

machine

Connection piece left

remove

plate

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17

Pas de commentaire

MTD FK 105 Manuel de service Page 9