MTD 45M4 Series Manuel de l'opérateur télécharger pdf (Page 8)

8 Section 3 — ASSembly & Set-Up

3. Secure chipper chute with the three cupped washers

(cupped side against the chipper chute) and hex nuts

previously removed. See Figure 3-6. Tighten the nuts at this

time.

Figure 3-6

Bag

4. Place the opening of the bag completely over the chute

deflector. See Figure 3-7.

5. Pull on the drawstring until the bag is tight around chute

deflector opening.

6. Clip drawstring back on itself, tight against chute deflector

to secure into position. See the inset of Figure 3-7.

Figure 3-7

3. Align the chute deflector in position on the discharge

opening and insert hex bolt with spacer through hinge on

chute deflector (spacers fit inside of hinges). See Figure 3-4A.

Figure 3-4

4. Place second spacer over hex bolt inside other hinge and

secure with hex lock nut. See Figure 3-4B.

5. Secure both sides of chute deflector to impeller housing

using wing knobs previously removed. See Figure 3-4C.

Chipper Chute

1. Remove the three cupped washers and hex nuts from

weld studs around the opening on the side of the impeller

housing. See Figure 3-5.

Figure 3-5

2. Align the chipper chute over the weld studs, so the slot in

the bottom of the chute is facing down. See Figure 3-6.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Pas de commentaire

MTD 45M4 Series Manuel de l'opérateur Page 8