Mtd 248-685-000 Manuel d'utilisateur

$1.00OWNER'S GUIDEOUTDOOR POWER EQUIPMENT for all seasonsIMPORTANT:Read Safety Rules and Instructions CarefullyPOWERVACUUMSModel Numbers 248-675-

CARBURETOR ADJUSTMENTAWARNINGIf any adjustments are made to the engine while the engine is running (e.g. carburetor), disengage all clutche

6. Slide impeller and blower housing assemblies off crankshaft.7. Remove belt from P.T.O. pulley and install new belt. See figure 20.NOTEWhen reasse

Models 675, 685 and 68912

675/685/689PARTS LIST FOR MODELS 675, 685, 689, 24677 and 24687 POWER VACUUMSf.J.PARTNO.COLORCODEDESCRIPTIONNEWPARTREF.NO.PARTNO.COLORCODEDESCRIPTIONN

Models 675, 685 and 68914

Models 675, 685 and 689PARTS LIST FOR MODELS 675,685,689, 24677 and 24687 POWER VACUUMSRef.No.PartNo.ColorCodeDescriptionNewPart114532 - 638 Air Duct

REPLACEMENT PARTS • RO. !JOX 36900 • CLEVELAND OHIO 44136

INDEXSafe Operation Practices... 3Assembly Instructions ... 4Operat

AIMPORTANTIt is suggested that this manual be read in its entirety before attempting to assemble or operate. Keep this manual in a safe place for futu

FIGURE 1y"HIT 8 J <ai^€> (?5 ® ® /.tMASSEMBLYINSTRUCTIONSCONTENTS OF HARDWARE PACK (See figure 1)A (1) Clutch Grip Assembly*B (1) Ha

1. Place nozzle (N) in position on front of housing so that it rests in flanges. Secure with one hand knob (F) and beileville washer (G). See figure

HAND KNOB (F)Place air duct assembly (P) over opening on top of housing. Secure with two hand knobs (F) and belleville washer (G). See figure 7.FIGURE

ROD (Q)FIGURE 10CLUTCHBRACKETASSEMBLY7. Slide the extension spring (D) onto clutch rod (Q) as shown in figure 10. Thread lock nut (E) onto clutch rod

5. Lift up and out on the housing and rotate it 105° clockwise. Chute opening should be to the righ*- hand side when viewed from the front of un See

OPERATIONBEFORE STARTING ENGINE*^rvice engine with gas and oil. See engine manual acked with vacuum for complete instructions for -care and maintenanc