MTD 769-01275C Manuel de l'opérateur

Safety • Assembly • Operation • Tips & Techniques • Maintenance • Troubleshooting • Parts Lists • WarrantyWarning: This unit is equipped with an i

10Gas & Oil Fill-Up Service the engine with gasoline and oil as instructed in the Tecumseh Engines manual packed separately with your snow thrower

114. Move throttle control to STOP position.5. Remove the ignition key and store in a safe place.6. Wipe all snow and moisture from the area around

124Making AdjustmentsAuger ControlRefer to Auger Control Test on Page 11 to adjust the auger control.Shift CableIf the full range of speeds (forward a

134Making AdjustmentsWARNINGLoose gravel can be picked up and thrown by the auger, causing injury to the operator and bystanders and/or damage to the

145Maintaining Your Snow ThrowerWARNINGBefore lubricating, repairing, or inspect-ing, disengage all controls and stop engine. Wait until all moving pa

155Maintaining Your Snow ThrowerAuger Belt ReplacementTo remove and replace your snow thrower’s auger belt, proceed as follows:1. Remove the plastic

16Augers• The augers are secured to the spiral shaft with two shear pins and cotter pins. If the auger should strike a foreign object or ice jam, the

17Friction Wheel RemovalIf the snow thrower fails to drive with the drive control engaged, and performing the drive control cable adjust-ment on page

187Off-Season StorageNever store snow thrower with fuel in tank indoors or in poorly ventilated areas, where fuel fumes may reach an open flame, spark

19NOTE: This section addresses minor service issues. For further details, contact a MTD authorized service center or call 1 (800) 800-7310 for assista

2Finding and Recording Model NumberPlease do NOT return the unit to the retailer from which it was purchased, without first contacting Customer Suppor

20 Styles E & F

215Illustrated Parts ListTo order replacement parts, contact 1-800-800-7310, or visit www.mtdproducts.com. 1. 731-2635 Snow Removal Tool Mount2.

22 Styles E & F

235Illustrated Parts ListTo order replacement parts, contact 1-800-800-7310, or visit www.mtdproducts.com. NOTE: Snow thrower features and component

24 

255Illustrated Parts ListTo order replacement parts, contact 1-800-800-7310, or visit www.mtdproducts.com. NOTE: Snow thrower features and component

NOTES26

NOTES27

The limited warranty set forth below is given by MTD LLC with respect to new merchandise purchased and used in the United States, its posses-sions and

31Safety LabelsWARNINGThis symbol points out important safety instructions which, if not followed, could endanger the personal safety and/or property

42Safe Operation PracticesTraining1. Read, understand, and follow all instructions on the machine and in the manual(s) before attempting to assemble

5Operation1. Do not put hands or feet near rotating parts, in the auger/impeller housing or chute assembly. Contact with the rotating parts can amput

65Setting Up Your Snow ThrowerNOTE: Reference to right and left side of the machine are observed from the operating position.1. Observe the lower re

75Setting Up Your Snow Thrower5. Remove the flat washer and hairpin clip from the end of the chute directional control. Insert the end of the chute

84Operating Your Snow ThrowerNow that you have set up your snow thrower for operation, get acquainted with its controls and fea-tures. These are descr

94Operating Your Snow ThrowerWARNINGThe operation of any snow thrower can result in foreign objects being thrown into the eyes, which can damage your