$1.00 ~N.OWNEirS GUIDE• ASSEMBLY • OPERATION • MAINTENANCE • PARTS •VERTICAL LOG SPLITTERModel Number 243-638-000IMPORTANT!Record the Model No. an
TO START ENGINEIMPORTANT: Refer to the separate engine manual for detailed starting instructions for your model.1. Place the engine shut-off sw
TO OPERATE LOG SPLIHER:1. Set throttle at maximum speed.2. Place the log upright, on top of end plate for vertical operation, and on top of beam fo
CARBURETOR ADJUSTMENTAWARNING: If any adjustments an; made to the engine while the engine is i unning (e.g. carburetor), keep clear of all noving
6.2. Using a 1/2 inch wrench, remove three nuts and lock washers which secure the pump to the coupling shield. Two nuts are at the bottom corners a
TROUBLi; SHOOTING GUIDETroublePossible Cause(s)Corrective ActionEngine fails to start1. Fuel tank empt'', or stale fuel. 1. Fill tank with c
HOW YOUR LOG SPLITTER OPERATESCylinder□^ CylinderDirectionalValveRelief ValveBreather Cap Unloading Valve 'PilotPressureLinePumpReservoirTHE PUMP
Model 638NOTE: The engine is not under warranty by the iog spiitter manufacturer. . .if repairs or service is needed on the engine, please contact you
Model 638PARTS LIST FOR MODEL 638 LOG SPLITTER<4EF.NO.PARTNO.CODEDESCRIPTIONREF.NO.PARTNO.CODEDESCRIPTION1 712-0359Slotted Nut 3/4-16 Thd.55781-037
HYDRAULIC TROUBLE SHOOTING GUIDEProblemProbable Cause(s) Corrective ActionCylinder rod will not moveA Broken driveshaft B Loose shaft coupf ng C Gear
IMPORTANT INFORMATION FOR LOG SPLITTER USERSALWAYS:Use clean fluid and check fluid level regularly Use Dexron II Automatic Transmission Fluid cr 10W n
For Replacement Parts, ContactSERVICE DEPARTMENT • P.O. BOX 368022 • CLEVELAND, OHIO 44136-9722
IMPORTANTRULES FOR SAFE OPERATIONATHIS SYMBOL POINTS OUT IMPORTANT SAFETY INSTRUCTIONS WHICH, IF NOT FOLLOWED, COULD ENDANGER THE PERSONAL SAFETY AND
2. Know how to stop the unit and disengage the cont [ols.3. Never place hands or feet between log and splitti ig wedge or between log and end plate
ASSEMBLY INSTRUCTIONSTools Required for Assembly(1) Soft Hammer or Mallet(2) 9/16" Wrenches*(2) 1/2" Wrenches*(1) 7/16" Wrench*(1) Ad
6. Place one flat washer just removed on each axle. Secure with hex slotted nut. Tighten slotted nut until snug, then back off approximately 1
Hex LockFIGURE 6.ControlHandleClevis Pin Cotter PinINSTALLING THE HITCH1. Using two 9/16" wrenches, remove the hardware which is assembled throu
FIGURE 9.ATTACHING THE HOSESSuction Hose1. The suction hose is attached to the reservoir tank, beneath the engine mounting bracket. See-----figure 9.
OPERATIONINITIAL PREPARATION1. Place the log splitter on a firm, level surface.2. Service engine with gasoline and oil asinstructed in the separate
Commentaires sur ces manuels