MTD 25cc Spécifications télécharger pdf (Page 53)

Clutch and Upper Drive Shaft

Clutch removal/replacement

NOTE: The upper drive shaft may be left connected to the

clutch housing. Removing the three screws in the

clutch housing will allow the clutch housing and the

upper drive shaft to be removed as one.

1. Remove the three screws holding the clutch housing

on with a T-20 driver. See Figure 7.5.

2. Disconnect and remove the spark plug.

3. Insert at least 18” (0.5 M) of starter rope in the spark

plug hole to keep the crank shaft from rotating. Keep

some of the rope out so it can be removed later.

See Figure 7.6.

4. Remove the clutch drum by removing the screw in

the center of it with a T-20 driver. See Figure 7.7.

Clutch housing

Figure 7.5

screws

Clutch housing screws

Figure 7.6

Insert at least 18” of rope

in the hole

Figure 7.7

Clutch drum

For Parts Call 606-678-9623 or 606-561-4983

www.mymowerparts.com

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 63 64

Pas de commentaire

MTD 25cc Spécifications Page 53