MTD 70 Series Spécifications télécharger pdf (Page 26)

AIR INTAKE SYSTEMS

7. Remove the screw that fastens the engine

shroud by the fuel tank using a #2 phillips screw

driver.

See Figure 3.4.

8. Remove the two carburetor nuts using a 10 mm

wrench.

See Figure 3.5.

9. Work the engine shroud off of the carburetor

studs.

NOTE: Be careful to pop the primer line out of

the notch that secures it while working the

engine shroud off.

See Figure 3.6.

10. Disconnect the fuel line from the fuel tank.

NOTE: The barb on the carburetor fuel inlet nip-

ple is very sharp and will damage the inside of

the fuel line if the fuel line is removed. Therefore

if the line is removed from the carburetor, it must

be replaced.

11. Disconnect the throttle linkage and return spring

from the carburetor.

See Figure 3.7.

Figure 3.4

Remove this screw

Figure 3.5

carburetor nuts

Figure 3.6

Pop primer line out of

notch while working the

shroud off

Figure 3.7

fuel line

disconnected

Throttle linkage

www.mymowerparts.com

For Discount White Outdoor Parts Call 606-678-9623 or 606-561-4983

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 88 89

Pas de commentaire

MTD 70 Series Spécifications Page 26