Mtd Y780 Manuel d'utilisateur télécharger pdf (Page 5)

INSTALL THE HARNESS

1. Push the strap through the center of the buckle.

2. Pull the strap over the cross bar and down through the slot

in the buckle (Fig. 3).

3. Put the harness

on over your head

and onto your

shoulder. Snap it

on to the support

fitting (Fig. 4).

4. Adjust the length

to fit the

operator’s size.

Pull the tab to

lengthen, pull the

strap to shorten

(Fig 5).

REMOVE AND INSTALL THE CUTTING SHIELD

Remove the cutting attachment shield when using the unit

as a brushcutter

Remove the cutting attachment shield from the shield mount

by removing the three (3) screws with a flat blade screwdriver

(Fig. 6). Store parts for future use.

ASSEMBLY INSTRUCTIONS

Install the cutting attachment shield when using the unit as

a grass trimmer

Install the cutting attachment shield on the shield mount by

inserting the three (3) screws into the shield mount. Tighten

securely with a flat blade screwdriver (Fig. 6).

REMOVE THE CUTTING ATTACHMENT AND INSTALL THE

CUTTING BLADE

NOTE:

To make cutting blade removal and installation easier,

place the unit on the ground or on a work bench

Remove the Cutting Attachment Shield

See Remove and Install the Cutting Attachment Shield.

Remove the Cutting Attachment

Align the shaft bushing hole with the locking rod slot and insert

the locking rod into the shaft bushing hole (Fig. 7).

2. Hold the locking rod in

place by grasping it next

to the boom of the unit

(Fig. 8).

3. While holding the locking

rod, remove the cutting

attachment by turning it

clockwise off of the

output shaft (Fig. 9). Store

the cutting attachment for

future use.

NOTE: The blade retainer

under the cutting attach-

Support Fitting

Fig. 4

Fig. 5

WARNING: Always use the shoulder harness

when using the cutting blade to avoid serious

personal injury.

WARNING: The cutting attachment shield should

NOT be installed when operating the unit with a

blade. Remove the cutting attachment shield

before removing or installing the blade.

WARNING: The gear housing gets hot with use.

It can result in injury to the operator. The housing

remains hot for a short time even after the unit is

turned off. Do not touch the gear housing until it

has cooled.

Fig. 7

Shaft Bushing Hole

Locking Rod Slot

Output Shaft

Bushing

Locking Rod

Output

Shaft

WARNING: To avoid serious personal injury, the

cutting attachment shield MUST be in place at all

times while operating the unit as a grass trimmer.

Fig. 8

Fig. 3

Cutting Attachment

Locking Rod

Slot

Locking Rod

Fig. 9

(3) Screws

Cutting

Attachment

Shield

Shield Mount

Gear Housing

Fig. 6

1 2 3 4 5 6 7 8 9 10 ... 55 56

Commentaires sur ces manuels

Pas de commentaire

Mtd Y780 Manuel d'utilisateur Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel de jardinage Mtd Y780