Mtd YM26CS EN Manuel d'utilisateur télécharger pdf (Page 5)

• Be sure the cutting attachment is not in contact with

anything before starting the unit.

• Use the unit only in daylight or good artificial light.

• Avoid accidental starting. Be in the starting position

whenever pulling the starter rope. The operator and

unit must be in a stable position while starting. See

Starting/Stopping Instructions.

• Use the right tool. Use this tool only for the purpose

intended.

• Do not overreach. Always keep proper footing and

balance.

• Always hold the unit with both hands when operating.

Keep a firm grip on both the front and rear handle or

grips.

• Keep hands, face and feet at a distance from all

moving parts. Do not touch or try to stop the cutting

attachment while it is rotating.

• Do not touch the engine, gear housing, or muffler. These

parts get extremely hot from operation and remain hot

for a short time after turning the engine off.

• Do not operate the engine faster than the speed

needed to cut, trim, or edge. Do not run the engine at

high speed when not cutting.

• Always stop the engine when cutting is delayed or

while walking from one cutting location to another.

• If you strike or become entangled with a foreign object,

stop the engine immediately and check for damage. Do

not operate before repairing damage. Do not operate

the unit with loose or damaged parts.

• Stop and switch the engine to OFF for maintenance,

repair, or for changing the cutting attachment or other

attachments.

• Use only replacement parts and accessories approved

by the manufacturer for this unit. These are available

from your authorized service dealer. Use of any non

approved parts or accessories could lead to serious

injury to the user, or damage to the unit, and void your

warranty.

• Keep unit clean of vegetation and other materials.

They may become lodged between the cutting

attachment and shield.

• To reduce fire hazard, replace faulty muffler and spark

arrestor, keep the engine and muffler free from grass,

leaves, excessive grease or carbon build up.

OTHER SAFETY WARNINGS

• Never store the unit, with fuel in the tank, inside a

building where fumes may reach an open flame or

spark.

• Allow the engine to cool before storing or

transporting. Be sure to secure the unit while

transporting.

• Store the unit in a dry area, locked up or up high

to prevent unauthorized use or damage, out of the

reach of children.

• Never douse or squirt the unit with water or any other

liquid. Keep handles dry, clean and free from debris.

Clean after each use. See Cleaning and Storage

Instructions.

• Keep these instructions. Refer to them often and use

them to instruct other users. If you loan someone this

unit, also loan them these instructions.

SAVE THESE INSTRUCTIONS

SECTION 1: RULES FOR SAFE OPERATION

1 2 3 4 5 6 7 8 9 10 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Mtd YM26CS EN Manuel d'utilisateur Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel de jardinage Mtd YM26CS EN