MTD 570 Series Manuel de l'opérateur télécharger pdf (Page 7)

Contents of Carton

One Log Splitter• One Tongue Assembly• One Operator’s Manual•

One Engine Operator’s Manual• One Tail Light Kit (If equipped)•

NOTE: This Operator’s Manual covers several models. Log splitter

features may vary by model. Not all features in this manual are

applicable to all log splitter models and the log splitter depicted

may differ from yours.

Use extreme caution unpacking this

machine. Some components are very heavy and will

require additional people or mechanical handling

equipment.

NOTE: All references in this manual to the left or right side of the

log splitter are from the operating position only. Exceptions, if

any, will be specified.

Assembly

Attaching the Jack Stand

The jack stand is shipped in the transport position.

Remove the spring clip and clevis pin, then pivot the jack 1.

stand towards the ground to the operating position.

Secure the jack stand in position with the clevis pin and 2.

spring clip. See Fig. 3-1.

Attaching the Tongue

With the log splitter still standing upright, remove the two 1.

hex bolts and hex nuts from the tank bracket. See Fig. 3-2.

Align the holes in the tongue with the holes in the tank 2.

bracket and secure with the hardware just removed. See

Fig. 3-2.

NOTE: The high pressure hose, which runs from the gear

pump the bottom of the control valve, must be above the

tongue assembly. See Section 8 (Illustrated Parts List) if you

are unsure of which hose is the high pressure hose.



















Assembly & Set-Up



1 2 3 4 5 6 7 8 9 10 11 12 ... 43 44

Pas de commentaire

MTD 570 Series Manuel de l'opérateur Page 7