Mtd 645C thru 650C Manuel d'utilisateur

OWNEirS GUIDE• ASSEMBLY • OPERATION • MAINTENANCE •V5 and 8 H.P. SHREDDERSModel Nos. 645C thru 650C(Model 645C Shown)IMPORTANT!Record the Model No.

I ITROUBLE SHOOTINGPROBLEMPOSSIBLE CAUSE!S)CORRECTIVE ACTIONEngine fails to start1. Fuel tank empty, or stale fuel.2. Spark plug wire cisconnected.3

I IModel No. -645C -648C -650CSpark PlugJ19LM J-8CJ19LMAir Filter Element !t91588 33268 393957Air Pre-Cleanerit91435 35881271794Engine Oil (SAE 30)737

Si\FETY RULESAWARNING: TO REDUCE THE PCITENTIAL FOR ANY INJURY, COMPLY WITH THE FOLLOWING SAFETY INSTRUCTIONS. FAILI RE TO COMPLY WITH THE INSTR

ASSEMBLY INSTRUCTIONSCtATTACHING THE UPPER GUIDE ASSEMBLYFlat Washer 5/16" I.D.Hex Lock Nut 5/16-18 ThreadHex Bolt-5/16-18 X 8-3/8" Long= =x

I IAWARNING: Make certain the spark plug wire is disconnected and movod away from the spark plug before assembling the shredder.AHACHIN

ATTACHING THE CATCHER BAGYour shredder is equipped with a catcher bag to catch the shredded material.To attach the bag, place the openi

I IBEFORE STARTING1. Place the shredder on a firm, level surfacs.2. Service engine with gasoline and oil as instructed in the separate eng

To lower the hopper assembly, use one hand to grasp the handle at the top of the hopper assembly and lift slightly. Pull up on th

I Imended at the start of each season; check engine manual for correct plug type and gap specifications.Clean the engine regularly with a

NOTE: When reassembling, make certain the opening on the back-up plate is toward the bottom of the unit. The back-up plate may b