MTD TBBC Instructions d'exploitation télécharger pdf (Page 14)

mNSTALUNG A PREWOUND REEL

1. Hold the outer spool with one hand and unscrew the

bump knob counterclockwise (Fig. 15). Inspect the boHt

inside the bump knob to make sure it moves freeHy.

RepHacethe bump knob if damaged.

2. Remove the oHdinner reeHfrom the outer spooH

(Fig. 16).

3. Remove the spring from the oHdinner reeH

(Fig. 16).

4. Mace the spring in the new inner reel

NOTE: The spring must be assemMed on the inner reeH

before reassemMing the cutting attachment.

5. Insert the ends of the Hinethrough the eyeHetsin the

outer spooH(Fig. 23).

6. Mace the new inner reeHinside the outer spool Push the

inner reeHand outer spooHtogether. WNe hoHdingthe

inner reeHand outer spool grasp the ends and pull firmly

to release the line from the holding slots in the spool.

7. Hold the inner reel in place and install the bump knob

by turning clockwise. Tighten securely.

AiR FILTER MAINTENANCE

Removing the Air Filter/Muffler Cover

WARNING: To voidserious

personal injury,

always turn your unit off and allow it to cool

before you clean or service it.

Remove the four (4) screws securing the air

filter/muffler cover (Fig. 24). Use a flat blade or

T20 Torx bit screwdriver.

2. Pull the cover from the engine. Do not force.

BmueEZ=Start TM

Lever

Cleaning the Air Filter

Clean and re-oil the air filter every 10 hours of operation.

It is an important item to maintain. Failure to maintain

your air filter properly can result in poor performance or

can cause permanent damage to your engine.

1. Remove air filter/muffler cover. Refer to Removing

the Air Filter/Muffler Cover.

2. Turn cover over and look inside to locate the air filter.

Remove the air filter from inside the air filter/muffler

cover (Fig. 25).

3. Wash the filter in detergent and water (Fig. 26). Rinse

the filter thoroughly. Squeeze out excess water. Allow

it to dry completely.

4. Apply enough clean SAE 30 oil to lightly coat the filter

(Fig. 27).

5. Squeeze the filter to spread and remove excess oil

(Fig. 28).

Air FHter

Fig. 25

Cover

Fig. 28

Screws

Fig. 24

Screws

Fig. 27 Fig. 28

6. Replace the air filter inside the air filter/muffler cover

(Fig. 25).

NOTE: Operating the unit without the air filter and air

filter/muffler cover assembly will VOID the

warranty.

Reinstalling the Air Filter/Muffler Cover

1. Place the air filter/muffler cover over the back of the

carburetor and muffler. Align the screw holes.

2. Insert the four (4) screws into the holes in the air

filter/muffler cover (Fig. 24) and tighten.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire

MTD TBBC Instructions d'exploitation Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Outils de jardin MTD TBBC