Mtd Self-Propelled Mower 979 Manuel d'utilisateur

IMPORTANT: READ SAFETY RULES AND INSTRUCTIONS CAREFULLYMTD PRODUCTS INC. P.O. BOX 368022 CLEVELAND, OHIO 44136-9722Warning: This unit is equipped with

10you to slip and fall. New grass, thick grass, or wet grass may require a narrower cut.For a healthier lawn, never cut off more than one-third of the

11SECTION 6: MAKING ADJUSTMENTSWARNING: Do not at any time make anyadjustments without first stopping engineand disconnecting spark plug wire.Cutting

12required due to normal wear on the cable. Adjustment is needed if all six speeds do not work.The adjustable cable bracket is located on the left sid

13• Periodically check all fasteners and make sure these are tight.• Follow the maintenance schedule under Customer Responsibilities to get quality pe

14speeds. It may cause damage to the mower, and could break causing personal injury.The blade can be tested by balancing it on a round shaft screwdriv

15 Figure 20• Place the new belt over the transmission pulley. Start the belt in the pulley groove and rotate the pulley until the belt is seated in

16• Refer to engine manual for correct engine storage instructions.• Coat mower’s cutting blade with chassis grease to prevent rusting.• Store mower i

17Notes

18Model 9791234567891011121314151617181920212223262729303132333435363738394041424344454647484945515052535456555757585960616263646566673369707172737475

19Model 979Ref. No.Part No. Part Description1. 747-0824 Control Handle2. 731-0904A Upper Control Handle3. 16864 6 Spd. Rack Cable Bracket4. 731-0620 C

2TABLE OF CONTENTSContent PageImportant Safe Operation Practices...3Slope Gauge...

20Model 97912345677891011121314147151617181920212223242526272829303031323334353637383940414243444546474849505152535455565758

21Model 979Ref. No.Part No. Part Description1. 720-0223 Grip2. 732-0803A Spring Lever3. 738-0529 Shoulder Nut .825 x .165 Lg.4. 710-0751 Cap Screw 1/

22

23

MANUFACTURER’S LIMITED WARRANTY FOR:The limited warranty set forth below is given by MTD PROD-UCTS INC (“MTD”) with respect to new merchandise pur-cha

3SECTION 1: IMPORTANT SAFE OPERATION PRACTICESWARNING: This symbol points out important safety instructions which, if not followed, could endanger th

4unclogging the chute. The cutting blade continues to rotate for a few seconds after the engine is shut off. Never place any part of the body in the b

53. Check the blade and engine mounting bolts at frequent intervals for proper tightness. Also, visually inspect blade for damage (e.g., bent, cracked

6SECTION 2: SLOPE GAUGEUse this page as a guide to determine slopes where you may not operate safely. Do not operate your lawn mower on such slopes

7SECTION 3: ASSEMBLING YOUR LAWN MOWERIMPORTANT: This unit is shipped without gasoline or oil in the engine. Be certain to service engine with gasol

8NOTE: Make certain the drive cable is routed aroundthe outside and above the lower handle so it does notinterfere with attaching the grass bag.• The

9SECTION 5: OPERATING YOUR LAWN MOWERWARNING: Keep hands and feet awayfrom chute area on the cutting deck. Theoperation of any lawn mower can result