Mtd YM25 Manuel d'utilisateur télécharger pdf (Page 13)

SECTION 7: MAINTENANCE AND REPAIR INSTRUCTIONS

Line Locking Hole

Trimming Line

Line Loading Hole

Eyelet

5. Insert the line into the locking hole. Do not push the

line more than a 1/2 inch (12.7 mm) into the line

locking hole. The line will form a small loop when it is

inserted correctly. See Figure 17.

3. Pull old line out of the line loading and line locking

holes. See Figure 16 and 17.

4. Insert a piece of trimming line straight into one of the

two eyelets in the outer spool. Push it up through the

line loading hole in the inner reel. See Figure 16. Do

not bend the line when inserting it into the eyelet.

6. Pull the line from the outer spool until the line is tight

against the inner reel. See Figure 18.

Installing a Pre-wound Reel

1. Turn the bump knob counterclockwise and remove

the bump knob, spring and foam seal. See Figure 21.

9. If winding the line becomes difficult or if the line

jams, pull the ends of the line from the spool. See

Figure 20. Continue winding the inner reel

counterclockwise.

7. Repeat procedures 4-6 with the second piece of line.

8. Hold the outer spool. Wind the inner reel

counterclockwise until approximately four (4) inches

(102 mm) of line remain. See Figure 19.

NOTE: Do not wind the inner reel before installing the

second piece of line.

Bump Knob

Foam Seal

Spring

Inner Reel

Figure 21

Figure 20

Figure 19

Figure 18

Figure 17

Figure 16

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 67 68

Pas de commentaire

Mtd YM25 Manuel d'utilisateur Page 13