MTD RM 33 LS Manuel de l'opérateur

MTD LLC, P.O. BOX 361131 CLEVELAND, OHIO 44136-0019Printed In USASafe Operation Practices • Set-Up • Operation • Maintenance • Service • Troubleshoot

10 Section 3— ASSembly & Set-Up3. Attach the end of the hose to the fitting on top of the filter. Place the hose clamp at the base of the fitting

11Section 3 — ASSembly & Set-UpSet-UpPreparing the Log Splitter1. Lubricate the beam area (where the splitting wedge will slide) with engine oil.

Controls & Features412TongueCylinderLog DislodgerWedgeControlHandleBeam AssemblyLog TrayVerticalBeam LockBeamSupportHorizontalBeam LockJack StandE

Operation513Starting the EnginePre-Start Checklist1. Remove the dipstick and check hydraulic fluid level. Refill if necessary. Approved fluids includ

14 Section 5— operation4. To place the beam in the Vertical Position proceed as follows:WARNING! Always use the log splitter in the vertical position

15Section 5 — operation3. To stabilize the log, place your left hand on the side of the log opposite the beam as shown in Figure 5-1. WARNING! Never

Maintenance & Adjustments616WARNING! Do not at any time make any adjustments without first stopping engine, disconnecting spark plug wire and grou

17Section 6 — Maintenance & adjuStMentSAdjustmentsWedge Assembly AdjustmentAs normal wear occurs and there is excessive “play” between the wedge a

Se rvice718Flexible Pump CouplerThe flexible pump coupler is a nylon “spider” insert, located between the pump and the engine shaft. Over time, the co

Tro u bleshooting819Problem Cause RemedyEngine fails to start 1. Spark plug wire disconnected.2. Fuel tank empty or stale fuel.3. Choke, if equippe

Customer SupportPlease do NOT return the machine to the retailer or dealer without first contacting the Customer Support Department.If you have diffic

20 Section 8 — troubleShootingProblem Cause RemedySlow cylinder shaft speed while extending and retracting.1. Gear sections damaged.2. Excessive pu

Replacement Parts921Component Part Number and Description737-0348A Vented Dipstick735-04103 Spider Bushing718-04395 Coupling, .875718-04392 Coupli

No tes1022

23Section 10 — noteS

Warranty Conditions — Australia (Not applicable to other Regions)The benefits given to you under this warranty are in addition to other rights and r

Important Safe Operation Practices23Training1. Read, understand, and follow all instructions on the machine and in the manual(s) before attempting to

4 Section 2 — important Safe operation practiceS13. If your machine is equipped with an internal combustion engine and is intended for use near any u

5Section 2 — important Safe operation practiceS11. When splitting in the vertical position, stabilize the log before moving the control handle. Split

6 Section 2 — important Safe operation practiceSSafety SymbolsThis page depicts and describes safety symbols that may appear on this product. Read, u

Assembly & Set-Up37Contents of Carton• One Log Splitter • One Operator’s Manual • One Engine Operator’s ManualWARNING! Use extreme caution when

8 Section 3— ASSembly & Set-UpAttaching The Wheels To The Reservoir Tank Assembly1. Block up the reservoir tank assembly about eight to twelve in

9Section 3 — ASSembly & Set-UpAttaching the tongue1. Remove the two hex bolts and lock nuts on the front of the reservoir tank.NOTE: The hardware