Mtd 217-310-000 Manuel d'utilisateur télécharger pdf (Page 7)

11. Place the handle panel (AB) in position on the

handles. Secure the upper holes in the panel to

the handles with carriage bolts (A), lock washers

------

(B) and hex nuts (C), finger tight only. See figure

10.

12. Place carriage bolt (A) through the handle panel,

handle and handle brace on the lower right hand

side of the handle panel, finger tight only. See

figure 10.

13. Place carriage bolt (A) through the handle panel,

handle, handle brace and cable support bracket

on the lower left hand side of handle panel as

shown in figure 11. Use the bottom hole in the

cable support bracket. Secure with lock washer

and hex nut, finger tight only.

FIGURE 11.

14. Place flat washer (I) between handle and upper

hole on cable support bracket. Secure with hex

------

washer head self-tapping screw (J). See figure 12.

15. Now tighten securely the self-tapping screw and

all nuts and bolts on handles and braces.

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Pas de commentaire

Mtd 217-310-000 Manuel d'utilisateur Page 7