Mtd 217-310-000 Manuel d'utilisateur télécharger pdf (Page 8)

A B

c y ^

FIGURE 13.

16. Assemble the throttle control to the handle panel

as follows.

A. Hold the throttle control assembly beneath the

handle panel. Turn the control sideways and

insert the lever up through the wide portion of

----------

the slot on the handle panel. See figure 13A.

B. After the end of the lever is through the slot,

turn and then tip the control forward as shown

in figure 13B to slide it through the slot.

NOTE

The lever must be all the way to the

back of the control housing as

shown in figure 13B.

C. Push the control back into the slot in the han

dle panel and press in place. Be certain the

control is locked securely into the slot. See

figure 13C.

D. Secure the throttle control to the handle panel

using Phillips head self-tapping screw provided.

See figure 13D.

17.

Hook the end of the clutch cable (already attached

to the tiller) over the extension spring as shown in

------

figure 14.

FIGURE 14.

NOTE

If spring has come loose, it must be

reassembled to the weld pin on the

idler bracket.

18.

Remove one nut and lock washer from other end

of clutch cable. Slip the wire up through slot on

cable support bracket. Start hex nut and lock

■ washer back on end of clutch cable. See figure 15.

Do not tighten at this time.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Pas de commentaire

Mtd 217-310-000 Manuel d'utilisateur Page 8