MTD 2M1 Manuel de l'opérateur télécharger pdf (Page 18)

Replacing Belt

Remove the belt cover by removing the five hex screws 1.

that secure it to the frame. See Fig. 7-1.

Remove the belt by grasping it from the bottom of the 2.

auger pulley and pulling outward.

NOTE: 

from under the belt keeper. See Fig. 7-1.

To replace the belt follow these instructions and refer to Fig. 7-2:

1.

2.

belt keeper.

Route the belt around the engine pulley.3.

4.

Reinstall the belt cover removed earlier.5.

















Service

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 47 48

Pas de commentaire

MTD 2M1 Manuel de l'opérateur Page 18