MTD K-Style Manuel de l'opérateur télécharger pdf (Page 17)

AugerShaft

At least once a season, remove the shear pins from the auger

shaft. Spray lubricant inside the shaft and around the spacers and

the flange bearings found at either end of the shaft.

See Fig. 6-3.

.....................................................................................................................................................................................................................................................................................

Figure 6-3

Adjustments

Shift Cable

If the full range of speeds (forward and reverse) cannot be

achieved, refer to the figures to the right and adjust the shift

cable as follows:

1. Place the shift lever in the fastest forward speed position.

2. Loosen the hex nut on the shift cable index bracket. See

Fig. 6-4.

Figure 6-4

3. Pivot the bracket downward to take up slack in the cable.

4. Retighten the hex nut.

AugerControl

Refer to the Assembly and Set-up section for instructions on

adjusting the auger control cable.

ChuteAssembly

Refer to the Assembly and Set-up section for instructions on

adjusting the skid shoes chute assembly.

Skid Shoes

Refer to the Assembly and Set-up section for instructions on

adjusting the skid shoes.

SECTION 6 -- MAINTENANCE & ADJUSTMENTS 17

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

MTD K-Style Manuel de l'opérateur Page 17

Commentaires sur ces manuels

Produits connexes et manuels pour Les souffleuses à neige MTD K-Style