MTD E150 Manuel de l'opérateur télécharger pdf (Page 6)

RAISING THE UPPER HANDLE

1. Loosen the hand knob on each side of the handle. Bee Figure 4. Remove packing material (if any).

2. Squeeze the control handle against the upper handle. Hold it in this position as you raise the handle.

3. Pull the handle up into the operating position. Be certain not to pinch the cable.

4. Tighten the hand knobs.

2.Squeeze

Control

Handle

&Pull 4. Tighten

Hand

1.Loosen Hand Knobs

Knobs

ATTACHING THE CONTROL CABLE

Figure 4

Bottom

Hole In

Control

Handle

of Cable

Housing

Plastic Fitting

Figure 5

The control cable may already be attached to the control handle, Complete steps two and three if cable is

loose.

Route the control cable over the lower handle. Place the end of the cable into the lower hole in the control

housing as shown in Figure 5. Push the plastic fitting until it locks into the control housing.

Lift the control handle up, and hook the "Z" end of the control cable into the bottom hole in the control handle,

from the outside to the inside (some models use only one hole). If necessary, use a pair of pliers to pull up on

the end of the cable to obtain slack in order to hook it into the control handle. Hold the "Z" fitting with the

pliers, not the cable, to avoid damaging the cable. (See inset - Figure 5.)

NOTE: The upper hole in the control handle provides for adjustment in belt tension. If you have only one hole in

the control handle, refer to Belt Tension Adjustment Section of this manual,

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Pas de commentaire

MTD E150 Manuel de l'opérateur Page 6