MTD GC720r Manuel de l'opérateur télécharger pdf (Page 10)

REPLACINGTHE SCRAPER

Use only original MTD replacement parts.

1. Place snow thrower on the ground or on work bench.

Position unit so vanes and rotor are facing up (Fig. 9).

2. Beneath the rotor, locate and remove the three (3)

screws securing the scraper to the housing using a

#T20 Torx bit or flat blade screwdriver (Fig. 9).

3. Remove the scraper and discard appropriately.

4. Reinstall the three (3) screws to secure new scraper

to the unit. Torque the screws to 25-30 in,lb

(2.8-3.3 N.m).

1 2 ... 5 6 7 8 9 10 11 12

Pas de commentaire

MTD GC720r Manuel de l'opérateur Page 10