MTD RZT Series Manuel de l'opérateur télécharger pdf (Page 12)

12 se c t i O n 4— cO n t r O l s a n d fe a t u r e s

Indicator Panel Features

Battery Indicator (Refer to Figure 4-4)

Illuminates and the battery voltage is displayed briefly



Illuminates to indicate the battery voltage has dropped

below 11.5 (+0.5/-1.0) volts. The battery voltage is also

displayed on the hour meter. If this indicator and display

come on during operation, check the battery and charging

system for possible causes and/or contact your Cub Cadet

dealer.

Oil Pressure Indicator (Refer to Figure 4-4)

This warning lamp indicates low engine oil pressure. If the

indicator comes on while the engine is running, stop the

engine immediately and check for possible causes. Do not

run the engine while this indicator is illuminated. Contact

your Cub Cadet dealer to have the tractor and engine

inspected.

NOTE

: The oil pressure indicator may illuminate when the

ignition switch is in the ON position, but should turn off when

the engine is started.

PTO Engaged Indicator (Refer to Figure 4-4)







the engine will not crank with the ignition switch in the





Parking Brake Engaged Indicator (Refer to Figure 4-4)

This indicator illuminates when the parking brake is in the









position.

This indicator also illuminates when the ignition switch is



control levers are in a position other than the fully out in

neutral position. Move the control levers fully outward.

M. Throttle Control





uniform engine speed will be maintained.



engine speed. The tractor is designed to operate with the

throttle control in the fast position (full throttle) when the

tractor is being driven and the mower deck is engaged.



engine speed.

N. Choke Control

The choke knob controls the position of the engine choke.



open the choke.

O. Parking Brake Engagement Lever

The parking brake engagement lever is located on the

front/left of the seat box frame, and is used to engage the

parking brake.







lower completely to disengage the parking brake.



fully opened out in the neutral position when engaging

the parking brake, the engine will stop. The parking brake

must be placed in the engaged position when starting the

tractor engine.

P. Model ZT54 ONLY - Transmission Oil

Expansion Reservoir

The transmission oil expansion reservoir is connected by



located beneath the seat box. The function of the reservoir

is to hold the natural expansion of transmission oil that





Under normal operating conditions, no oil should be





above the bottom of the reservoir.

NOTE:

oil level in the reservoir may be slightly higher than the



tractor will eventually purge the air from the lines and the

oil level will settle to the maximum.

Rear Bumper (Not Shown)

The tractor is equipped with a removable rear bumper. The

rear bumper provides protection to the rear of the tractor

frame and engine during turns.

The rear bumper must be removed from the tractor when



the bumper to reduce the over-all length of the tractor. To

Remove the rear bumper, proceed as follows:

From the inside surface of the tractor frame, just 

rearward of the rear tire on either side of the tractor,

pull the internal cotter pin from the clevis pin. Move to

the other side of the tractor and remove the internal

cotter pin from the other clevis pin. Refer to Figure 3-4

if necessary.

While supporting the rear bumper, withdraw the clevis 

pin from both sides of the bumper, and pull the rear

bumper rearward off of the tractor frame.

This symbol indicates

the fast position

This symbol indicates

the slow position

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

MTD RZT Series Manuel de l'opérateur Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Tracteur MTD RZT Series