MTD 752Z170-L0 Manuel de l'opérateur télécharger pdf (Page 14)

i ii i_,i

Figure 6-1

12. Fill with the recommended Oil, Fig. 6-3.

(

7. Tip engine to position the oil flow, so it will drain from the

lowest point on the engine.

8. Drain the oil into an approved recyclable oil container.

NOTE: Please dispose of used motor oil in a ma nner that is

compatible with the environment. We suggest you take it in a

sealed container to your local service station for reclamation.

Do not throw it in the trash or pour it on the ground.

9. Install the oil drain plug and tighten securely.

10. Clean area around the oil drain plug.

11. Remove the oil fill cap dipstick.

Figure 6-2

WARNING! Used motor oil may cause skin cancer if

repeatedly left in contact with the skin for

prolonged periods. Although this is unlikely unless 16.

you handle used oil on a daily basis, it is still

advisable to thoroughly wash your hands with soap 17.

and water as soon as possible after handling used

oil.

18.

_30

40 mm_.

20w40,_Ow50 ____

15w40, 0_ _ _ _ m_lbl,,.

lOw40___lmJbb

10w30____

(°C)-30° -20° -10° 0° 10° 200 300 400

(°F)-20° 0° 200 400 600 800 100°

Fig. 6-3

NOTE: DO NOT overfill oil filler. Doing so may result in oil

carry-over to the equipment and cause malfunction or

damage.

NOTE: DO NOT allow oil level to fall below and "L" mark on

dipstick. Doing so may result in equipment malfunction or

damage.

13. Wipe away any spilled oil.

14. Check the oil level by installing the Oil Fill Cap/Dipstick.

For threaded Oil Fill Cap/Dipstick models, rest

the cap on the threads, do not tighten down the

cap to check the oil level.

For quarter-turn Oil Fill Cap/Dipstick models,

tighten down the cap to check the oil level.

NOTE:See the Set-Up section earlier in this manual for

detailed instructions on identifying and checking the oil on

each of these specific engine models.

15. Remove the oil filler cap/dipstick. If the level is low, slowly

add oil until oil level registers between high (H) and low (L),

Fig. 3-2 and 3-3 in the Set-Up section.

Repeat Steps 14 & 15 to be sure that the correct oil level has

been achieved.

Once the proper oil level has been confirmed, install the Oil

Fill Cap/Dipstick. Tighten securely

Carefully disconnect spark plug wire from grounding post,

if present.

19. Carefully reconnect the spark plug wire to the spark plug.

NOTE: It is advisable to recheck the oil level after you have

operated the engine for a short while, and the normal engine

operating temperature has been achieved.

_ ARNING! If the engine has been running, the

muffler, engine head and spark plug will be very hot.

Be careful not to touch any of these components

until they have cooled.

SECTION 6-- MAINTENANCE

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

MTD 752Z170-L0 Manuel de l'opérateur Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Outils de jardin MTD 752Z170-L0