MTD 752Z170-L0 Manuel de l'opérateur télécharger pdf (Page 7)

CheckingOilLevelon Engineswith ThreadedOil Fill Caps

NOTE; Be sure to check the oil while on a level surface with the

engine stopped.

To avoid engine damage, it is important to:

Check oil level before each use and every S operating

hours when engine is warm. Check oil level more

frequently during engine break-in.

Keep oil level between "H" and "L" marks on dipstick.

See Fig. 3-3.

Be sure to rest oil fill cap on the threads when

checking. Do not tighten down oil fill cap when

checking the oil on threaded oil fill cap engines.

I. Remove the oil filler cap/dipstick and wipe the dipstick

clean. See Fig. 3-3.

2. Insert the cap/dipstick into the oil filler neck, but do not

screw it in.

3. Remove the oil filler cap/dipstick. If the level is low, slowly

add oil until oil level registers between high (H) and low (L),

Fig. 3-3.

4. Replace and tighten cap/dipstick firmly before starting

engine.

NOTE: Do not overfill. Overfilling with oil may cause smoking,

hard starting, or spark plug fouling.

NOTE: DO NOTallow oil level to fall below the "L" mark on the

dipstick. Doing so may result in equipment malfunctions or

damage.

NOTE: To change the oil on your engine, see the Maintenance

Section of this manual.

FillingOil Sump

I. Be sure the engine is upright and level.

2. Remove the oil fill cap dipstick from oil filler tube by

rotating counter-clockwise and lifting the dipstick out of

the engine. Wipe the dipstick clean with a shop rag.

3. Insert oil fill cap dipstick back into oil filler tube. On

quarter-turn oil fill caps, tighten by rotating the cap

clockwise until firmly seated.

NOTE:Some units may have a threaded dipstick. In this

instance, insert the cap/dipstick into the oil filler neck, but

do not screw it in to check.

4. Loosen and remove the oil fill cap dipstick from the oil

filler tube. Note the oil level, if oil reading on the dipstick

is below the "L" mark, slowly add oil to reach the "H" level.

See Fig. 3-2 or 3-3, whichever is applicable.

S. Insert oil fill cap dipstick back into oil filler tube. Tighten by

rotating the cap clockwise until firmly seated.

6. Wipe away any spilled oil.

/VOTE:To change the oil, see Checking and Changing Oil

instructions in the Maintenance Section of this manual.

Figure 3-3

SECTION2 -- SET-UP 7

1 2 3 4 5 6 7 8 9 10 11 12 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

MTD 752Z170-L0 Manuel de l'opérateur Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Outils de jardin MTD 752Z170-L0