Mtd Yard-Man YM90BC Manuel d'utilisateur télécharger pdf (Page 5)

INSTALL THE HARNESS

1. Push the strap through the

center of the buckle.

2. Pull the strap over the cross

bar and down through the slot

in the buckle (Fig. 5).

3. Put the harness on over head

and onto shoulder. Snap it on

to the support fitting (Fig. 6).

4. Adjust length to fit the operator’s

size. Pull tab to lengthen, pull

strap to shorten (Fig 7).

Support Fitting

Fig. 6

Fig. 7

REMOVE AND INSTALL THE CUTTING ATTACHMENT SHIELD

Remove the cutting attachment shield when using the unit

as a brushcutter

Remove the cutting attachment shield from the shield mount

by removing the three (3) screws with a flat blade screwdriver

(Fig. 4). Store parts for future use.

REMOVE THE CUTTING ATTACHMENT AND INSTALL THE

CUTTING BLADE

NOTE: To make cutting blade removal and installation easier, place

the unit on the ground or on a work bench

Remove the Cutting Attachment Shield

See Remove and Install the Cutting Attachment Shield.

Remove the Cutting Attachment

Align the shaft bushing hole with the locking rod slot and insert

the locking rod into the shaft bushing hole (Fig. 8).

(3) Screws

Cutting

Attachment

Shield

Shield Mount

Gear Housing

Fig. 4

ASSEMBLY INSTRUCTIONS

WARNING: The cutting attachment shield should

NOT be installed when operating the unit with a

blade. Remove the cutting attachment shield

before removing or installing the blade.

WARNING: Always use the shoulder harness

when using the cutting blade to avoid serious

personal injury.

WARNING: The gear housing gets hot with use.

It can result in injury to the operator. The housing

remains hot for a short time even after the unit is

turned off. Do not touch the gear housing until it

has cooled.

Fig. 5

Install the cutting attachment shield when using the unit as

a grass trimmer

Install the cutting attachment shield on the shield mount by

inserting the three (3) screws into the shield mount. Tighten

securely with a flat blade screwdriver (Fig. 4).

WARNING: To avoid serious personal injury, the

cutting attachment shield MUST be in place at all

times while operating the unit as a grass trimmer.

Shaft Bushing Hole

Locking Rod Slot

Output Shaft

Bushing

Locking Rod

Output Shaft

Fig. 8

2. Hold the locking rod in place by grasping it next to the

boom of the unit (Fig. 9).

3. While holding the locking

rod, remove the cutting

attachment by turning it

clockwise off of the output

shaft (Fig. 10). Store the

cutting attachment for

future use.

NOTE: The blade retainer

under the cutting

attachment will be

used when installing

the cutting blade.

Fig. 9

Cutting Attachment

Locking Rod

Slot

Locking Rod

Fig. 10

1 2 3 4 5 6 7 8 9 10 ... 55 56

Commentaires sur ces manuels

Pas de commentaire

Mtd Yard-Man YM90BC Manuel d'utilisateur Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel de jardinage Mtd Yard-Man YM90BC