Mtd E762F Manuel d'utilisateur télécharger pdf (Page 10)

Figure 15

FINAL ADJUSTMENTS

Auger Drive Clutch

To check the adjustment of the auger drive clutch,

push forward on the left hand clutch grip (depress

the rubber bumper). There should be slack in the

cable. Release the clutch grip. The cable should be

straight. Make certain you can depress the auger

drive clutch grip against the left handle completely.

If necessary, loosen the hex jam nut and thread the

cable in (for less slack) or out (for more slack) as

necessary. Refer to Figure 15. Recheck the

adjustment. Tighten the hex jam nut against the

cable when correct adjustment is reached.

Traction Drive Clutch and Shift Lever Adjustment

To check the adjustment of the traction drive clutch

and shift lever, move the track lock lever to the

transport position and the shift lever all the way left

to fifth (5) position. With the traction drive clutch

released, push the snow thrower forward to check

that the tracks turn.

NOTE: It may be necessary to “rock” the snow

thrower backward, then forward, to start the tracks

turning.

Engage the traction drive clutch and push the snow

thrower. The tracks should not turn. Release the trac-

tion drive clutch and make sure the tracks again turn.

Move the shift lever back to the reverse position, then

all the way forward again. There should be no resis-

tance in movement of shift lever.

If you have resistance when moving the shift lever or

you are unable to turn the tracks by pushing the snow

thrower, loosen the lock nut on the traction drive

cable and unthread the cable one turn. If you are able

to turn the tracks when you engage the traction drive

clutch grip, loosen the lock nut on the traction drive

cable and thread the cable in one turn. Recheck and

repeat adjustment as necessary. Tighten the lock nut

to secure the cable when correct adjustment is

reached.

NOTE: If you are uncertain that you have reached

the correct adjustment, refer to the Adjustment

section.

Skid Shoe Adjustment

The space between the shave plate and the ground

can be adjusted. For close snow removal, place skid

shoes in the low position. Use middle or high

position when area to be cleared is uneven.

Adjust skid shoes by loosening the four hex nuts and

carriage bolts and moving skid shoes to desired

position. Make certain the entire bottom surface of

skid shoe is against the ground to avoid uneven

wear on the skid shoes. Retighten nuts and bolts

securely. See Figure 16

It is not recommended that you operate this snow

thrower on gravel as loose gravel can be easily

picked up and thrown by the auger causing an injury

or damage to the snow thrower. If you do wish to

use the snow thrower on gravel, refer to “Track Lock

Lever” instructions in the Control section.

Figure 16

Traction

Drive

Clutch

Shift Lever

Hairpin

Clip

Flat

Washer

Shift

Rod

Ferrule

Lower

Hole in

Shift

Lever

Hairpin

Clip

Flat

Washer

Shift

Arm

Assembly

Skid

Hex Nuts

Shoes

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 29 30

Commentaires sur ces manuels

Pas de commentaire

Mtd E762F Manuel d'utilisateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Voitures Mtd E762F