Mtd E762F Manuel d'utilisateur télécharger pdf (Page 6)

SECTION 5: ASSEMBLY INSTRUCTIONS

IMPORTANT: After assembly, service engine

with gasoline, and check oil level as instructed in the

separate engine manual packed with your unit.

NOTE: All references to right or left side of the

snow thrower are determined from behind the unit in

the operating position.

UNPACKING

1. Remove staples or break glue on the top flaps of

the carton. Remove any loose parts like

operator’s manual or hardware pack included

with unit.

2. Cut the carton along its corners and lay the end

of the carton down flat. Remove packing

material.

3. Roll unit out of carton. Check carton thoroughly

for loose parts.

4. Extend cables out behind unit and lay them on

the floor.

5. Lay out the contents of the hardware pack

according to the illustration on page 5 and

identify each part.

6. Find the loose parts in the carton and lay these

on the floor. You should locate the following

loose parts in the carton:

Tools Required

The snow thrower comes partly assembled in the

carton. You will have to complete the assembly.

Follow assembly instructions in this operator’s

manual to make the job safe and easy. You will need

the following tools to assemble the snow thrower.

Attaching the Handle Assembly.

(Hardware A)

Lay loose parts out on flat surface.

Figure 2

1. Attach left handle and grip bracket to handle

panel with two carriage bolts, lock washers and

hex nuts. (Be sure the bend in the grip bracket is

towards the center of the handle panel. (See

Figure 3.) Do not tighten at this time.

Figure 3

2. Locate auger control grip, part #4 in Figure 2.

The triangular metal tab on the auger control

grip must face the center of the handle panel.

1. Handle Panel

2. Right Handle

3. Left Handle

4. Auger Control Grip

5. Traction Drive Control Grip

6. Right Clutch Grip Bracket

7. Left Clutch Grip Bracket

8. Shift Rod (Not Illustrated)

9. Chute Crank Assembly (Not Illustrated)

10. Chute Assembly (Not Illustrated)

11. Hardware Pack (Not Illustrated)

A. Set of Wrenches (3/8", 9/16", 1/2" or

adjustable)

B. Pair of pliers

1. Handle Panel

2. Right Handle

3. Left Handle

4. Auger Control Grip

5. Traction Drive

Control

Grip

6. Right Grip Bracket

7. Left Grip Bracket

Handle Panel

Carriage

Bolts

Left Grip Bracket

Panel

Lock Washers

(curves in)

Outer

of Handle

Edge

Left Handle

and Hex Nuts

1 2 3 4 5 6 7 8 9 10 11 ... 29 30

Commentaires sur ces manuels

Pas de commentaire

Mtd E762F Manuel d'utilisateur Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Voitures Mtd E762F