Mtd 217-310-000 Manuel d'utilisateur télécharger pdf (Page 6)

7. Remove the clevis pin and hairpin cotter from the

— inner tine assemblies as shown in figure 7. Place

the right and left hand tine assemblies in position

on tine shaft. Secure with clevis pins and hairpin

cotters.

■i^NOTE

Be certain the tine assemblies are

assembled on the tine shaft so that

the sharp edge of the tines enter the

soil first. See figure 7.

FIGURE 7.

Tine

Shield

Extension

(AD)

Hex Bolts (Q)

/Lock Washers (R)

Hex Nuts (S)

Left Hand

Handle (AA).

8. Attach the tine shield extension (AD) to the tine

shield and frame on the right side of the unit as

— shown in figure 8. Secure with hex bolts (Q), lock

washers (R) and hex nuts (S). Tighten securely.

9. The left handle has a clutch grip already assem

bled to it. Assemble the left and right hand handles

(AA and Z) to the rear tiller frame as shown in figure

8. Secure with hex bolts (D), lock washers (B) and

hex nuts (C), finger tight only (do not tighten).

FIGURE 8.

Lock Washer (B) Hex Nut (C)

Handle

Braces (U)

Hex Bolt (D)v

High

Position Low

Position

10.

Attach the right and left hand braces (U) to the

tailpiece. The braces have two holes to provide

handle height adjustment Select hole for either

high or low position. Secure to tailpiece with hex

bolts (D), lock washers (B) and hex nuts (C), finger

------

tight only (do not tighten). See figure 9.

FIGURE 9.

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Commentaires sur ces manuels

Pas de commentaire

Mtd 217-310-000 Manuel d'utilisateur Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel de jardinage Mtd 217-310-000