Mtd YM26BC Manuel d'utilisateur télécharger pdf (Page 5)

• To reduce fire hazard, replace a faulty muffler and

spark arrestor. Keep the engine and muffler free from

grass, leaves, excessive grease or carbon build up.

While Operating with the Cutting Blade

• Read and understand all safety warnings before

operating this unit.

• Always use the shoulder harness when using the

brush blade accessory.

• Keep the J-handle between the operator and cutting

attachment or blade at all times.

• NEVER cut with the cutting blade located over 30

inches (76 cm) or more above the ground level.

• Blade thrust may occur when the spinning blade

contacts an object that it does not immediately cut.

Blade thrust can be violent enough to cause the unit

and/or operator to be propelled in any direction , and

possibly lose control of the unit. Blade thrust can

occur without warning if the blade snags, stalls or

binds. This is more likely to occur in areas where it is

difficult to see the material being cut.

• For operation with the brush blade, do not cut

anything thicker than 1/2 inch or a violent kickback

could occur.

• Do not attempt to touch or stop the blade when it is

rotating.

•A coasting blade can cause injury while it continues to

spin after the engine is stopped or the throttle trigger

is released. Maintain proper control until the blade has

completely stopped rotating.

• Do not run the unit at high speed when not cutting.

• If you strike or become entangled with a foreign

object, stop the engine immediately and check for

damage. Have any damage repaired before attempting

further operations. Do not operate unit with a bent,

cracked or dull blade. Discard blades that are bent,

warped, cracked or broken.

• Do not sharpen the cutting blade. Sharpening the blade

can cause the blade tip to break off while in use. This can

result in severe personal injury. Replace the blade.

• Do not use the cutting blade for edging or as an

edger, severe personal injury to yourself or others can

occur. Use the cutting blade only for the purpose as

described in this manual.

•Stop the engine IMMEDIATELY if you feel excessive

vibration. Vibration is a sign of trouble. Inspect thoroughly

for loose nuts, bolts or damage before continuing. Repair

or replace affected parts as necessary.

After Use

• Clean cutting blades with a household cleaner to

remove any gum buildup. Oil the blade with machine

oil to prevent rust.

• Lock up and store the cutting blade in an appropriate area

to protect the blade from unauthorized use or damage.

Other Safety Warnings

• Never store a fueled unit inside a building where fumes

may reach an open flame or spark.

• Allow the engine to cool before storing or transporting.

Be sure to secure the unit while transporting.

• Store the unit in a dry area, locked up or up high to

prevent unauthorized use or damage, out of the reach

of children.

• Never douse or squirt the unit with water or any other

liquid. Keep handles dry, clean and free from debris.

Clean after each use, see Cleaning and Storage

instructions.

• Keep these instructions. Refer to them often and use

them to instruct other users. If you loan someone this

unit, also loan them these instructions.

SAVE THESE INSTRUCTIONS

1 2 3 4 5 6 7 8 9 10 ... 95 96

Commentaires sur ces manuels

Pas de commentaire

Mtd YM26BC Manuel d'utilisateur Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel de jardinage Mtd YM26BC