Mtd YM26CO Manuel d'utilisateur télécharger pdf (Page 18)

MAINTENANCE AND REPAIR INSTRUCTIONS

NOTE: Always use the correct line length when installing

trimming line on the unit. The line may not release

properly if the line is too long.

Single Line Installation

Go To Step 8 for SplitLine™ Installation

6. Take approximately 16 feet (5 m) of new trimming

line, loop it into two equal lengths. Insert each end of

the line through one of the two holes in the inner reel

(Fig. 37 or 38). Pull the line through the inner reel so

that the loop is as small as possible.

7. Wind the lines in tight even layers, onto the reel

(Fig. 39 or 40). Wind the line in the direction indicated

on the inner reel. Place your index finger between the

two lines to stop the lines from overlapping. Do not

overlap the ends of the line. Proceed to step 11.

Slotted

Holes

For Use with SplitLine™

or Single Line

For Use with Single

Line ONLY

Loop

Indexing Teeth

Fig. 34

Fig. 39

Fig. 33

3. Remove spring from the inner reel (Fig. 31 or 32).

4. Use a clean cloth to clean the the inner reel, spring,

shaft and inner surface of the outer spool (Fig. 33).

5. Check the indexing teeth on the inner reel and outer

spool for wear (Fig. 34 or 35). If necessary, remove

burrs or replace the reel and spool.

Fig. 37

Indexing Teeth

Loop

YM26BC

YM26C0

Fig. 38

YM26BC

YM26C0

Fig. 35

Fig. 36

NOTE: SplitLine™ can only be used with the inner reel

with the slotted holes. Single line can be used on

either type of inner reel. Use Figure 36 to identify

the inner reel you have.

YM26BC

Fig. 40

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 103 104

Commentaires sur ces manuels

Pas de commentaire

Mtd YM26CO Manuel d'utilisateur Page 18

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel de jardinage Mtd YM26CO