Mtd YM90 Manuel d'utilisateur télécharger pdf (Page 12)

SECTION 5: STARTING/STOPPING INSTRUCTIONS

WARNING: Operate this unit only in a well- ventilated

outdoor area. Carbon monoxide exhaust fumes can be

lethal in a confined area

WARNING: Avoid accidental starting. Make sure you are

in the starting position when pulling the starter rope.

See Figure 18. To avoid serious injury, the operator and

unit must be in a stable position while starting.

To avoid serious personal injury, ensure any Add-On

being used is installed correctly and secure before

starting unit.

Stopping Instructions

1. Release your hand from the throttle control.

See Figure 18. Allow the engine to cool

down by idling.

2. Push and hold the On/Off Stop Control in

the OFF (O) position until the engine stops

running. See Figure 16

On/Off Stop Control

Start/On (I)

Stop/Off (O)

Throttle Control

Starter Rope

Throttle Control

Primer

Bulb

EZ-Start™

Lever

Figure 18

Figure 17

Figure 16

Starting Instructions

IF... You are starting a warm engine, begin at step 4.

1. Mix gas with oil. Fill fuel tank with fuel/oil mixture.

See Oil and Fuel Mixing Instructions.

2. Make sure the On/Off Stop Control is in the ON (I)

position. See Figure 16.

3. Fully press and release the primer bulb 10 times,

slowly, until FUEL IS VISIBLE IN THE PRIMER

BULB. See Figure 17. If you can’t see fuel in the

bulb, press and release the bulb as many times as it

takes before you can see fuel in it.

4. Push the EZ-Start™ Lever to the left until it clicks and

locks into place. See Figure 17.

5. With the unit in the starting position, DO NOT

SQUEEZE THE THROTTLE CONTROL. See Figure

18. Pull the starter rope 5 times briskly, making sure the

EZ-Start™ lever is pushed to the left.

IF... The engine does not start, go back to step 3.

IF... The engine starts to run before the fifth pull, go to step 6.

IF... The outside temperature or engine temperature

exceeds 90º F and the engine fails to start after 5

pulls, fully squeeze the throttle control and pull the

starter rope briskly 3 to 8 more times. The engine

should start within these pulls.

NOTE: When starting, the EZ-Start™ Lever will automatically

click off when you squeeze the throttle control.

6. When the engine starts, squeeze the throttle control to

warm up the engine for 5 to 10 seconds. The EZ-

Start™ Lever will click off automatically. See Figure 17.

...

The engine stalls while squeezing the throttle, go

back to step 4.

IF... The engine stalls before you squeeze the throttle

control, hold the throttle control and pull the starter

rope until the trimmer starts.

Throttle Lock-Out

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 81 82

Commentaires sur ces manuels

Pas de commentaire

Mtd YM90 Manuel d'utilisateur Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel de jardinage Mtd YM90